What the blower motor does
The blower motor spins a squirrel-cage wheel that pulls air from your return vents, pushes it across the heat exchanger (or the heat strips in an electric system), and sends it through the ducts. In most Schertz homes, the same blower also moves air for the air conditioner, so a blower failure affects you year-round.
There are two main types:
PSC motor
Permanent split capacitor: the traditional single-speed or multi-tap motor. It needs a run capacitor and is less expensive to replace.
ECM motor
Electronically commutated, or variable-speed: quieter and more efficient, adjusting airflow precisely. It costs more, and its electronic module can fail on its own.
Signs of a failing blower motor
- The furnace fires but little or no air comes out of the vents
- A hum from the furnace with no airflow, often a failed capacitor
- Squealing or screeching, from worn bearings or (on older units) a belt
- The blower runs constantly and won't shut off, often a relay or control issue
- The furnace overheats and trips the limit switch because air isn't moving heat away
- A burning or hot electrical smell near the furnace
Turn the furnace off if you smell burning or the blower hums without spinning. A stalled motor can overheat, and running the burners without airflow stresses the heat exchanger.
Common causes
- Failed run capacitor (PSC). The most common and least expensive blower repair. Capacitors weaken with heat, which is why attic furnaces in Schertz lose them sooner.
- Worn bearings from age, causing noise and then seizing.
- Dirty blower wheel. Caked dust makes the motor work harder and run hotter.
- Clogged filter or blocked returns, which strain the motor, especially ECM motors that ramp up to compensate.
- Power surges and lightning, which can damage ECM electronics. Central Texas storms are a common trigger.
How we diagnose it
- Check the call for fan from the control board and thermostat.
- Test the capacitor against its microfarad rating (PSC motors).
- Measure motor amperage and voltage, and check for overheating and bearing play.
- For ECM motors, test the module and motor separately. Sometimes only the module needs replacing.
- Inspect the wheel for dirt, imbalance or a loose set screw.
Repair, replace or upgrade?
If the capacitor failed, replacing it may be all you need. If the motor itself failed, replace it with an exact match or an approved equivalent. Some PSC systems can be upgraded to an aftermarket constant-torque ECM motor for quieter, more efficient operation. We'll tell you if it makes sense for your furnace.
Blower motor repair cost
| Item | Typical cost | Notes |
|---|---|---|
| Run capacitor replacement | $120 – $350 | Blower hums but won't spin |
| PSC blower motor replacement | $450 – $900 | Standard single/multi-speed motors |
| ECM module only | $400 – $900 | When only the electronics failed |
| ECM motor replacement | $900 – $1,800 | Variable-speed motor and module |
| Blower wheel cleaning | $150 – $350 | Restores airflow and reduces strain |