Technicians on call now · Schertz, Cibolo & Universal City Furnace & heating repair · Written price before work
Schertz, TX

Furnace cleaning in Schertz, TX

Dust, pet hair and cedar pollen build up inside a furnace and quietly cut its efficiency. A professional cleaning restores airflow and clean combustion, and often fixes nuisance shutdowns.

A standard tune-up includes light cleaning. A full furnace cleaning goes further, for furnaces that have gone years without service or live in dusty conditions.

Signs your furnace needs a cleaning

  • The burners light, then shut off after a few seconds (a dirty flame sensor)
  • Weak airflow from the vents even with a new filter (a caked blower wheel)
  • A strong dusty smell that lasts more than an hour after start-up
  • Yellow, uneven or noisy burner flames
  • Visible dust or debris inside the furnace cabinet
  • No professional service in two years or more, or the home was recently renovated (drywall dust)

What a full furnace cleaning includes

Burners

Removed or brushed and vacuumed so the flame burns clean and blue, which supports efficient, safe combustion.

Flame sensor

Cleaned of the oxide layer that causes "lights, then shuts off" problems, and tested in microamps.

Blower wheel

A dirty wheel can cut airflow significantly. We clean the blades and check the motor and capacitor.

Cabinet and return

Dust, debris and pet hair vacuumed from the cabinet, filter rack and return plenum near the unit.

Condensate system

Trap, drain line and pan flushed on high-efficiency and attic units to prevent lockouts and leaks.

Safety check

Carbon monoxide test, heat exchanger inspection and full heating cycle test after cleaning.

Furnace cleaning vs duct cleaning

They're different services. Furnace cleaning focuses on the equipment, where dirt directly affects safety and performance. Duct cleaning targets the air ducts throughout the house. The EPA notes that duct cleaning hasn't been shown to prevent health problems in most homes, but it can make sense if there's visible mold growth, vermin, or excessive debris after a renovation. We'll tell you honestly whether your ducts need attention.

Cedar season tip: mountain cedar pollen peaks in Central Texas from about December through February, right in heating season. Check your filter monthly during those months to keep the furnace clean between visits.

Furnace cleaning cost in Schertz

Typical furnace cleaning costsParts and labor, Schertz / San Antonio area, 2026 estimates. You get an exact written price before work begins.
Item Typical cost Notes
Full furnace cleaning $120 – $350 Burners, sensor, blower, cabinet, drain
Blower wheel deep clean $150 – $350 When removal is required
Flame sensor cleaning only $90 – $175 Often done during a repair call
Tune-up (light cleaning included) $80 – $200 Annual maintenance visit
FAQ

Furnace Cleaning FAQs

Don't see your question? Call (210) 898-9282.

How often should a furnace be cleaned?

Light cleaning happens during every yearly tune-up. A full deep cleaning is usually needed only every few years, or sooner in homes with pets, heavy dust or recent renovation.

Can I clean my furnace myself?

You can change the filter, vacuum around the unit and keep the area clear. Cleaning the burners, flame sensor and blower involves gas and high-voltage components and should be done by a technician.

Will cleaning lower my energy bill?

If the blower or burners were dirty, yes. Restoring airflow and clean combustion helps the furnace heat faster and run shorter cycles. A furnace that was already clean won't see much change.

Furnace down? Get your heat back today.

Licensed furnace repair in Schertz, TX, with a written price before work and 24/7 emergency service.

Call Now Free Estimate