Technicians on call now · Schertz, Cibolo & Universal City Furnace & heating repair · Written price before work
Schertz, TX

Attic furnace repair in Schertz, TX

Water stain on the ceiling? Furnace shutting off for no clear reason? Many Schertz homes have horizontal furnaces in the attic, and they have their own set of problems. We fix them.

Builders across the San Antonio area put furnaces in attics to save interior space. It works, but it puts the furnace in one of the harshest spots in the house: scorching in summer, cold in winter, and right above your ceiling drywall.

Why attic furnaces fail differently

Summer heat damage

Texas attics can climb well past 130°F. Months of that heat dry out wire insulation and age capacitors and control boards long before they'd fail in a closet.

Condensate overflow

High-efficiency furnaces and the AC coil on top of them produce water. When the drain clogs with algae or debris, water backs up into the pan, and then into your ceiling.

Pressure switch lockouts

A clogged condensate trap stops the pressure switch from closing, so the furnace refuses to light. This is a very common attic furnace call.

Disconnected or crushed ducts

Flex ducts in attics get stepped on, sag or come loose, sending heated air into the attic instead of your rooms.

Water from an attic furnace: what to do right now

If water is dripping through your ceiling: turn the system off at the thermostat, put a bucket and towels under the drip, and if the ceiling is bulging, carefully poke a small hole at the lowest point to drain it into a bucket (this prevents a larger collapse). Then call us.

Attic HVAC systems are supposed to have two lines of defense against leaks:

  1. Primary drain line carries water from the coil and furnace to a drain or outside.
  2. Secondary drain pan under the unit catches overflow, with either a separate secondary drain line (often ending above a window, a hint that something's wrong) or a float switch that shuts the system off before the pan overflows.

If water reached your ceiling, one or both of these failed: the pan may be rusted through, the float switch missing or stuck, or the secondary line clogged too. We clear the drains, test the float switch, inspect the pan and fix whatever let the water through.

Tip: if water is dripping from a pipe over a window or on an exterior wall, your primary drain is clogged and the secondary line is working. Call before the pan fills up.

What an attic furnace repair includes

  • Clearing and flushing primary and secondary condensate lines, and the furnace's internal trap on high-efficiency units
  • Testing or adding a float (overflow) switch
  • Inspecting the drain pan for rust, cracks and standing water
  • Checking wiring, capacitors and the control board for heat damage
  • Inspecting the flue for proper slope and secure joints through the roof
  • Checking ducts and connections near the unit for leaks or disconnects
  • Full ignition and safety testing, including a carbon monoxide check

Attic access and safety

Building codes call for a clear path and a solid working platform to attic equipment, along with lighting. Some older installations have neither, which makes repairs slower and riskier. We'll let you know if access needs improving. Better access also makes every future repair and tune-up quicker and cheaper.

Prevent the next attic leak

Most attic drain clogs are preventable. A yearly tune-up includes flushing the condensate line and testing the float switch. Between visits, pouring a cup of white vinegar into the drain line access every few months can slow algae growth (ask your technician where your access port is).

Attic furnace repair cost in Schertz

Attic repairs can take longer than closet repairs because of access and heat. These are typical ranges:

Typical attic furnace repair costsParts and labor, Schertz / San Antonio area, 2026 estimates. You get an exact written price before work begins.
Item Typical cost Notes
Condensate drain clearing $120 – $300 Primary and secondary lines
Float (overflow) switch install $120 – $250 Shuts the system off before the pan overflows
Drain pan replacement $250 – $600 Rusted or cracked pans
Condensate pump replacement $180 – $450 Where gravity drainage isn't possible
Heat-damaged capacitor or board $120 – $900 Capacitor at low end, control board at high end
FAQ

Attic Furnace Repair FAQs

Don't see your question? Call (210) 898-9282.

Why is water leaking from my attic furnace?

Almost always a clogged condensate drain. The furnace (if high-efficiency) and the AC coil above it produce water that should drain away. Algae and debris block the line, the pan fills, and water overflows. See furnace leaking water.

Does my attic furnace need a float switch?

It's strongly recommended. A float switch shuts the system off when water rises in the pan, which can prevent ceiling damage. It's an inexpensive part that pays for itself the first time it trips.

Is it bad to have a furnace in the attic?

Not necessarily. It's very common in Texas. Attic furnaces just need extra attention to drainage, heat-damaged parts and duct connections. Yearly maintenance matters more than for a closet unit.

Can a furnace be moved out of the attic?

Sometimes, during a replacement, if there's room in a closet or garage and the ductwork can be adapted. It's a bigger project, but some homeowners find it worthwhile for easier service.

Furnace down? Get your heat back today.

Licensed furnace repair in Schertz, TX, with a written price before work and 24/7 emergency service.

Call Now Free Estimate