Turn the thermostat off, switch off the furnace's power switch (or breaker) for about 30 seconds, switch it back on, then set the thermostat to HEAT. Reset only once. If the furnace locks out again, call a technician instead of resetting repeatedly.
Why furnaces lock out
Modern furnaces try to ignite a few times. If ignition keeps failing, or a safety switch keeps tripping, the control board enters lockout and stops trying. Many boards automatically retry after about an hour (a "soft lockout"). Lockout is a safety feature that keeps unburned gas from building up and keeps a malfunctioning furnace from overheating.
How to reset a furnace
- Turn the thermostat to OFF.
- Before resetting, count the LED flashes through the furnace's sight window. The code points to the cause. See blinking light codes.
- Turn off the furnace power switch (a light-style switch on or near the unit) or its breaker.
- Wait about 30 seconds.
- Turn power back on and make sure the furnace door panel is fully seated.
- Set the thermostat to HEAT a few degrees above room temperature and listen for the start-up sequence.
What about the reset button?
Many modern furnaces don't have a single reset button. Some have:
- A red button on the blower motor (older units): a thermal overload that trips when the motor overheats. If it trips again, the motor or airflow has a problem.
- A manual-reset rollout switch near the burners. If it trips, flames rolled out of the burner area, possibly from a blocked flue or damaged heat exchanger. Don't reset it repeatedly. Have it inspected.
- A manual-reset limit switch on some models, which trips on overheating, usually from a clogged filter.
Don't reset if: you smell gas, a CO alarm is sounding, you hear a loud bang at ignition, there's water around electrical parts, or the rollout switch has tripped. Turn the furnace off and call.
Why repeated resets are risky
- Each failed ignition attempt can release a little unburned gas.
- Overriding overheating protection stresses the heat exchanger.
- You lose the diagnostic code that would help a technician fix the real problem.
Fix the cause, not the symptom
Common reasons a furnace locks out: a dirty flame sensor, a cracked igniter, a clogged condensate trap, or a clogged filter causing overheating. Most are affordable repairs.